Milli Developer Kit v1.0 with Arduino
This product is approved for for use in USA,Canada, Jamaica and Australia. Now available for shipping.
Milli Arduino shield with Arduino M0 Pro or Adafruit Metro M0 Express - requires at least one IoT Edge Router HW1 - USA, Canada & Jamaica or IoT Edge Router HW2 - Australia & Singapore (with WAN mode) device for communication with the network. MiniAPs have been discontinued.
TheItron Networked Solutions’ Milli 5 is a cost-effective, energy-efficient sub-GHz wireless communications device. The Milli 5 is optimized for a wide range of 802.15.4g network applications and is the first in the family of such devices. It may be integrated with battery-powered devices such as water meters, photocells, and logistics pallet tracking devices. It comes equipped with on-board firmware that supports communications in an IPv6 wireless mesh network. This Milli 5 based developer kit uses an Arduino shield for easy integration with any compatible Arduino R3 boards. Firmware currently supports CoAP over UART communication with integrated devices.
Included in Dev Kit:
- Milli 5 NIC Arduino shield board
- Arduino M0 Pro or Adafruit Metro M0 Express
- USB/TTL smart cable
- Micro USB Cable
- Quick Start Guide
We also recommend you purchase any sensors you wish to integrate along with a breadboard and connecting wire.
The following countries are supported.
|NAN1 BAND||CC*||HW||FREQUENCY BAND||POWER||COUNTRIES|
|AUS||36||2||915-928 MHz||350 mW (eirp)||
|USA||840||1||902-928 MHz||350 mW (eirp)||
USA, CAN, JAM
* The CC is the "country code" that will be used to configure the device for the proper country frequency band.
*Note: Requires at least one IoT Edge Router HW1 - USA, Canada & Jamaica or IoT Edge Router HW2 - Australia & Singapore (with WAN mode) device for communication with the network. IoT Edge Router Inventory on Back Order. This Item is Currently Unavailable.