This product is approved for use in European Union (EU) countries.

Milli Arduino shield with Arduino M0 Pro - requires an IoT Edge Router HW3 - Europe & Middle East (with WAN mode) device for communication with the network.

The Itron Networked Solutions’ Milli 5 is a cost-effective, energy-efficient sub-GHz wireless communications device. The Milli 5 is optimized for a wide range of 802.15.4g network applications and is the first in the family of such devices. It may be integrated with battery-powered devices such as water meters, photocells, and logistics pallet tracking devices. It comes equipped with on-board firmware that supports communications in an IPv6 wireless mesh network. This Milli 5 based developer kit uses an Arduino shield for easy integration with any compatible Arduino R3 boards. Firmware currently supports CoAP over UART communication with integrated devices.

Included in Dev Kit:

• Milli 5 NIC Arduino shield board
• Arduino M0 Pro
• Antenna
• USB/TTL smart cable
• Micro USB Cable
• Quick Start Guide

We also recommend you purchase any sensors you wish to integrate along with a breadboard and connecting wire.

The following countries are supported.

* The CC is the "country code" that will be used to configure the device for the proper country frequency band.

Note: Requires at least one IoT Edge Router HW3 - Europe & Middle East  (with WAN mode) and Generic Wireless HW3 Accessory Kit for communication with the network.