This product is approved for use in the USA, Canada, Jamaica, and Australia. Now available for shipping.
Milli Arduino shield with Arduino M0 Pro or Adafruit Metro M0 Express - requires at least one IoT Edge Router HW1 - USA, Canada & Jamaica or IoT Edge Router HW2 - Australia & Singapore (with WAN mode) device for communication with the network. MiniAPs have been discontinued.
The Itron Networked Solutions’ Milli 5 is a cost-effective, energy-efficient sub-GHz wireless communications device. The Milli 5 is optimized for a wide range of 802.15.4g network applications and is the first in the family of such devices. It may be integrated with battery-powered devices such as water meters, photocells, and logistics pallet tracking devices. It comes equipped with on-board firmware that supports communications in an IPv6 wireless mesh network. This Milli 5 based developer kit uses an Arduino shield for easy integration with any compatible Arduino R3 boards. Firmware currently supports CoAP over UART communication with integrated devices.
Included in Dev Kit:
- Milli 5 NIC Arduino shield board
- Arduino M0 Pro or Adafruit Metro M0 Express
- USB/TTL smart cable
- Micro USB Cable
- Quick Start Guide
We also recommend you purchase any sensors you wish to integrate along with a breadboard and connecting wire.
The following countries are supported.
|NAN1 BAND||CC*||HW||FREQUENCY BAND||POWER||COUNTRIES|
|AUS||36||2||915-928 MHz||350 mW (eirp)||
|USA||840||1||902-928 MHz||350 mW (eirp)||
USA, CAN, JAM
* The CC is the "country code" that will be used to configure the device for the proper country frequency band.