Milli Developer Kit v1.0 - EU
This product is approved for for use in European Union (EU) countries. Shipping available at the end of June, 2018.
Milli Arduino shield with Arduino M0 Pro - requires an IoT Edge Router HW3 - Europe & Middle East (with WAN mode) IoT Edge Router Inventory on Back Order device for communication with the network.
The Itron Networked Solutions’ Milli 5 is a cost-effective, energy-efficient sub-GHz wireless communications device. The Milli 5 is optimized for a wide range of 802.15.4g network applications and is the first in the family of such devices. It may be integrated with battery-powered devices such as water meters, photocells, and logistics pallet tracking devices. It comes equipped with on-board firmware that supports communications in an IPv6 wireless mesh network. This Milli 5 based developer kit uses an Arduino shield for easy integration with any compatible Arduino R3 boards. Firmware currently supports CoAP over UART communication with integrated devices.
Included in Dev Kit:
- Milli 5 NIC Arduino shield board
- Arduino M0 Pro
- USB/TTL smart cable
- Micro USB Cable
- Quick Start Guide
We also recommend you purchase any sensors you wish to integrate along with a breadboard and connecting wire.
The following countries are supported.
|EU BAND||CC*||FREQUENCY BAND||POWER||COUNTRIES|
|EU873||826||870-873 MHz||500 mW erp||
CHE, EST, FIN, GBR, HUN, ISL, IRL, LUX, PRT, SWE
|EU876||208||870-875.6 MHz||500 mW erp||
ALB, DNK, MDA, NOR, SVN
* The CC is the "country code" that will be used to configure the device for the proper country frequency band.